Samples

Hello I am in Montreal Canada, we have a deck of 2ftx2ft squares of hard wood semi-open slats. 18 years old. I am not looking for more than protecting the wood and an enduring stain rather than one or two years. Normally I just sand and stain. After 18 years I think this must have worked, some distortion is happening and disintegration of the base wood that never got stained but overall its a great achievement. So, I think of just sanding and buying your stain. thanks for any comment.

We have a two year old cedar fence we are going to apply a finish to. This fence replaces one we put up in the summer of ‘89. We used Floods CWF clear. We liked the “golden” color (and it lasted).
We are looking at using your transparent. Does it bring out the natural just sawn coloring? How long should we expect it to last?
Thank you!

Hi, I'm looking for some advice.
I'm planning on re-staining our deck, Can you tell what kind of wood I have In my deck and suggest what product I should buy?

I built a porch swing with Ipe. The original finish did not last. I want to sand and refinish it. I am concerned about it drying and sitting on it after finishing it. I would like to finish it close to the natural wood color. Thanks!

Hi. Could you please advise as to whether your semi-solid stain is recommended for use on our railing system and on the porch floor. I was thinking of Amber on the floor and mountain Cedar on the railing. If that stain is not suitable, can you recommend another of your products please?

Do we need to clean the porch floor with something given it has been installed for some time? The wood types and their exposure to the weather are noted below.

The railing is cedar, all constructed last summer, stored inside and installed in late April, 2020. The railing is white cedar except for the upcoming post caps which will be red cedar (caps yet to be cut to size and bevelled - and thus not weathered yet).

The porch floor and stair steps are made of pressure-treated pine, installed about 8 years ago. Our exposure is south. Porch is covered, steps and edges of porch (and thus railing system) are exposed to rain. We live in Ontario, Canada.

Is it possible to have the small can samples of stain shipped to Ontario?

Lastly, since it is on our wish list for... if anything was possible... can a stain be tinted (at a price) to more closely match an existing colour, e.g., the siding colour on our home? The Benjamin Moore Paint colours on our home are: HC 103- Cromwell Grey, and HC 104 - Copley Grey. Thank you.

I live in Quebec and have a brand new deck as of May 12. It is treated pine. My deck is very shaded by large trees all late spring, summer, and early fall. Can I use a transparent stain?

Hi..in Ohio..full sun abg pool deck about 8 yrs old. Should I use semi transparent or semi solid? Pressure washing first. Will either peel? Before I buy samples I want to know what opaquisity to use. I wd like it to last a few yrs bc its a big deck and expensive to have someone stain it

I put a coat of AC semi-transparent drift wood grey on my deck and it's not as grey as I would like it. If I put a second coat on will that bring more grey out?

was thinking of using your product on older treated lumber..not a fan of stains so was thinking of going with transparent stain natural tone. ..do your transparent stains peel over time or should i stick with a sealer? thx in advance

I would like to have the AC stain used on my deck applied by a professional. It was done 2 years ago but needs another application. Problem is that I cannot find anyone who knows about the product and how to use it. The company that did it last time is no longer doing decks and cannot recommend anyone else. How can I find a competent professional who knows how to use AC on my Ipe deck. I am in zip code 18940. Do you have a list of professionals in my area?

I started to stain a new cedar fence and don’t like it, I would like to keep the natural wood look, can I remove the stain that I applied? Is there a product that would only enhance the natural wood grain/color. The wood is semi rough what size nap roller do I need, maybe I’m not applying it correctly , I’m using a 3/8 nap roller, I did not prep it, seems to not roll on smoothly but it just looks dull and flat , no wood grain.

I am restoring a small 50 year old deck. I do not know the type of wood. Because it is a cantilever deck, we must save and preserve the floor joists that extend back into the house. We are replacing the rim boards and decking with pressure treated lumber. I need to stain the floor joists now because some will need a new sister for support and this will be the last time for a long, long time we will have access to them. The new wood obviously will need to season before staining sometime next year. With both old and new wood, what do you recommend for stain, semi-transparent or solid? And do you have a retailer anywhere near Kansas City? Thank you.

I bought semi-transparent stain to redo the rough cedar siding on my house. The original stain used was SIKKENS Cetol SRD translucent stain, but you can no longer get this in an oil-based formula in Canada so I chose to change to Armstrong Clark. The south and west side of the house take a beating from the sun in the summer, so I went with semi-transparent this time. After using the new stain on the railings and sides of our upstairs patio, my wife is concerned about the opaqueness of the semi-transparent. Can it be thinned down with something to reduce the pigment to oil ratio? Any other suggestions?

I'm using semi-trans natural oak on exterior cedar patio structure. Should a wood pre-conditioner be used prior to staining to prevent blotching?

Can a semi transparent stain be used on a exterior wood coffee table ? My wife wants me to sand it down and stain it.

Can a Semi-Solid Stain be used on top of a Semi-Transparent stain?

We have a new deck and are trying to match our deck color to Minwax Special Walnut hardwood stain which is on our den floor. Our wall in the den is mostly windows and opens up to the deck. We are not having any luck at Lowes or Home Depot and just found your stain listed high on a Deck Stain review website. Does anyone have an actual picture of the semi-transparent Natural Oak?

Looking for some advice on untreated southern yellow pine. I’ve built a cedar deck and used Armstrong-Clark before, turned out great. This T&G pine will go underneath a covered porch.

For a new pine KDAT covered deck on screened porch, can I apply AC prior to install? Or is it necessary to install, wait 1-2 months, then prep? If prep is required, what is the product or kit from AC?

can you use this stain over existing stain

Is this a one step process, do I put anything on top of the stain

Which of the semi-solid options is closest to a medium brown? I don't want any orange/red hue. And, I don't want something that is dark and will get hot.

What is the most popular semi solid color?

You list "Semi-Trans Black Walnut" as a sample color, but I do not see that color on the color chart. The only Black Walnut I see is under "Hardwoods and Softwoods." We want to order the following samples: Semi-Solid Espresso, Semi-Solid Oxford Brown, and Hardwoods & Softwoods Black Walnut.

We will be adding another coat this spring. Hopefully that will hold up another year. Decks are a lot of maintenance to keep them looking nice. Here is what it looked like last fall after staining rustic brown. We live in Indiana and deck tends to fade in winter. It always looks darker when you first apply.

I'm getting your Restore A Deck kit but i'm not sure which stain I should use. I have southern yellow pine and I hear it's difficult to stain. Can you recommend a stain? I was thinking about the Cedar or Natural Oak from the Semi Transparent Stains but i'll go with whichever looks best.

Any experience or luck with mixing rustic brown with driftwood together for an application.

Stained the cedar railing of my porch last spring with semi-transparent cedar and there was a noticeable darkening, almost mildewy appearance over the last few months. Stripped off stain and am going to reapply. I was wondering if applying a polyurathane or other sealant over the newly stained wood would help preserve the color better.

Will this stain work well in an air sprayer?

Hello, I have been reading reviews about your products and I could use help for my specific concerns regarding my deck. We have a 30 year old red oak deck that is in pretty good condition, however, we did have some rotting woods planks that we had to have replaced. We were ill advised and originally told we couldn’t get replacement boards in red wood and ended up replacing boards with pressurized treated wood. We’ve only power washed at this point, but plan to use RAD strip and brightener before staining the deck. With the wood types being and looking so vastly different, would a dark-semi solid work for them to look like the same colors when stained? Or, are we going to need a solid stain?